Do i put 2 inch rigid foam on the cinder block wall it would be over the drain and then add the stud wall to meet.
Stud out a concrete wall with french drain.
We plugged the original dime sized hole but obviously the water still seeps through in that general area it would be fine to leave that area unfinished.
The lip is 2 25 inches high and 6 5 inches deep.
As for the inside if water get s in and runs down the wall you must have a gap between the framing and the wall to let it run into the drain tile.
See pics do i frame the walls right on top of the lip or do i put the frames in front of it frames will essentially be 6 5 inches away from the wall in this case.
It is not an external french drain its a french drain along the walls that drain into a sump pump.
What i want to do is to put up walls.
My basement has a french drain around the perimeter.
Now here are my questions.
I have been looking for a solution but keep getting french drain external results.
Basement is about 50x30 ft.
I have french drains around the perimeter of the basement with a little curb like lip in front of the walls.
You can bump the framing out in front of the drain but you will lose a lot of space that way.
The water seeps into the french drain in one corner only.
To clarify i want to put a stud wall along the edge of the perimeter drain.